Spettacolare preamplificatore accuphase in ottime condizioni è perfettamente funzionante This control amplifier was released as the first of the Accuphase series. The company name at that time was Kensonic. The equalizer circuit is fully push-pull driven by direct connection to all stages to improve the bare characteristics before NFB (negative feedback) is applied, making it a high fidelity amplifier circuit. To handle input signals in a wide dynamic range, an A-class drive pure complimentary service is used in the final stage of the equalizer, and a dual plus / minus power supply system ensures a high allowable input voltage. In addition, a low-enhancement circuit is used to enhance the sense of volume when listening to music. An attenuator that can be continuously adjusted by 10 dB is provided to adjust the level of the DISC1 and DISC2 cartridges when you want to lower the level of an extremely high-power cartridge to an appropriate level, or when you want to listen to a comparison of two cartridges using DISC1 and DISC2. In addition, DISC1 is equipped with an input impedance selector switch, which allows you to select between 47k Ω, 30k Ω and 20k Ω. A 25-Hz cutoff subsonic filter is also provided for disc playback. Equipped with independent left and right tone control, the turnover frequency can be switched between 200 hz, 400 hz, 2.5 khz and 5 khz for low and high tones respectively. The change characteristic is ± 10 dB with a 11-contact rotary switch. It is equipped with a low filter of 12dB/oct at 30 Hz or less to cut subsonic noise. It is also equipped with a 5 khz, 12dB/oct high filter to cut hissing from tapes. Tape I/O is installed in the Route 3 so that three tape recorders can be connected. Two of them are capable of dubbing each other. The copy switches are independent, so that it is possible to dub each other while listening to the source. A dedicated amplifier directly connected to pure complimentary service is installed for the headphone to improve the sound quality of the headphone. All amplification stages are supplied from a power supply with a completely constant voltage to improve stability. The speaker selector switch on the front panel allows you to switch the speaker system using a special relay box (sold separately) when the power amplifier is set out of reach.