A microprocessor controlled compact player. Fully working properly and sounding very good. Just minor signs of use. New LEDs placed in the sensors for correct arm movement. Begin and end point set correct on 7" and 12". Very nice sounding original stylus. 7" adapter included. A non-contact tone arm controlled by a microprocessor is mounted on the tone arm drive system. In addition, an electronic servo lifter is adopted to realize smooth arm operation. The tone arm is equipped with a light weight straight arm. A quick repeat system is adopted, and the record is lead-in without returning to the armrest. The cartridge is equipped with DL-60 MM type cartridge. DENON quartz is used for the drive part to improve rotational accuracy. Uses a dust cover with opaque coating on the back of the ceiling. The operation part uses a soft type push button, and by eliminating the unevenness of the button, the design quality is improved. An insulator is equipped as a howling countermeasure. 33-45 rpm are Quartz stabilized. Type Full auto player Phono Motor Section Drive system Servo-operated direct drive Motor Linear drive motor Speed control Speed servo and phase servo by frequency detection Number of revolutions 33 1/3, 45 rpm Speed selector button Non-lock self-illumination type Wow and flutter 0.02% W. rms or less (rotating system) 0.03% W. rms or less (JIS measurement method) Rotational speed deviation 0.002% or less Signal-to-noise ratio 75 dB or more (DIN-B) Startup time Within 2 Seconds (33 1/3) Load characteristic 0% (Needle Pressure 80g Outer Circumference) Voltage characteristic 0% for 90 ~ 110 V Turntable Aluminum Die Cast 30 cm Arm Section Type Electronic Dynamic Balance, Shell Integrated Straight Semi-Integrated Effective length 220mm Overhang 16mm Tracking error 3 degrees or less Needle pressure control 0 ~ 3g Applicable Cartridge Dead Weight About 4-6g Head shell PCL-30 Dedicated Type Output code Low Dose Cord Approx. 1.2m Model Name DL-60 Output voltage 2.5mV Playback frequency 20 Hz to 30 kHz Needle pressure 1.8 ± 0.3g Compliance 10x10-6cm/dyne Needle exchange DSN-60:¥8,000 Cabinet Special rigid resin integral molding Pwer 220V VAC, 50Hz/60Hz Power consumption 6W External dimensions Width 365x Height 100x Depth 335 mm (With Dust Cover Closed) Weight Approx. 5.5 kg Signs of use and a microscopic postcode at the lower left side Carefully insured shipped